Register
Log In
Home
August 28, 2009
Offline
February 28, 2011
Offline
Looking good!
I'm relatively new to DWs but that stainless has kinda grown on me. I can tell that I'll be needing a Seven-something or other at some point. Right now, I'm at entry-level 14s and 15s.
Both of my DWs are Monson builds, and I've read all about the Monson this and that, but, beyond the internet hype, what is the skinny on the Norwich or Palmer guns? I've still got to think that they're way past being a step above a stick!
VERY nice .41 ! I've been looking for classy guns and I think that one definitely has it! 
March 25, 2008
Offline
Very sweet looking, you got the whole mariann with that one
nice find! harly
Range Officer
Range Officers
Dans Club
March 27, 2009
Offline
April 8, 2011
Offline
I see you see that one on GB...
December 26, 2010
Offline
Sweet! Congrats on the new additions.
Supporter
Moderators
January 24, 2009
Offline
Excellent finds! 
Trading for a 741 would be a no-brainer in my book. It's much easier to find another FN, from what I've seen.
Dans Club
May 17, 2009
Offline
February 11, 2010
Offline
A Norwich Pack.....Awesome ! Congrats 
-Blacktop
Supporter
Range Officer
Range Officers
May 2, 2009
Offline
Nice snag--741's need to be bought when you find them.
SHOOT
Range Officer
Range Officers
Dans Club
February 28, 2009
Offline
Nice trade, Harly. What model is PP No.2?
C5rider said:
Both of my DWs are Monson builds, and I've read all about the Monson this and that, but, beyond the internet hype, what is the skinny on the Norwich or Palmer guns?
OK, here goes: Monson guns are the original guns so a lot of us prefer them.
Palmer guns receive a largely undeserved bad rap because the Palmer plant had QC issues. However, DW willingly and without charge repaired all the guns that were returned to them with QC issues. Therefore, any Palmer gun you find is probably just fine because if there were any issues they have most likely been addressed.
Norwich guns are probably the best for quality of fit, finish, and assembly.
Both the Monson and Palmer guns suffer from cylinders which are not totally flat on the front. This requires very carefully setting the cylinder gap at the tightest cylinder position.
Hope this answers your question.
-Mike
February 28, 2011
Offline
I think it does that quite well. Thank you and again, AWESOME 741 ! Thanks for sharing!
December 26, 2010
Offline
They're gorgeous. When money allows a stainless 41 is high on my list. Congrats on the acquisitions.
April 25, 2008
Offline
Nice 741. 
I also have a Norwich 741, the development gun for the SRS series.
The Savantist
December 27, 2010
Offline
September 10, 2010
Offline
Without a beard you are no different from any woman or child.
1 Guest(s)
