Dans Club
March 2, 2008
I've had the chance to do some comparison of two clamp on scope mounts for Dan Wesson revolvers, the B Square and the Burris
Here's my 2-6x mounted on the B Square, and below that on the Burris
The Burris is by far my favorite. It allows mounting the scope much lower, is easier to take off and remount without removing the scope from the mount, and is nicer looking. Unfortunately, it is no longer made and fairly difficult to find.
One advantage with the B Square is that it will mount on both small and large frame DW's, the Burris will not. It is also much more widely available, and uses Weaver rings, which may be a little easier to install.
The finished product:
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
Supporter
Moderators
January 24, 2009
Range Officer
Range Officers
Dans Club
February 9, 2009
DWF Supporters
Dans Club
Moderators
November 17, 2008
Supporter
Moderators
January 24, 2009
June 5, 2008
Top is old B-Square no longer available, middle is current B-Square mount and bottom is current DW that requires shroud to be Drilled &Tapped. Sorry about quality of picture, my digital camera is 10 year old Sony. The new B-Square mount sit's too high in my opinion causing to much devation of impact point at verious ranges. The DW D&T mount is only way to go in my book. I guess I will order a new mount for the 715 and see if I can get some of my money back by selling the new B-Square mount, probably $30 will get it delivered that will save someone $10 or more.
Revolvers
New Model M-715 Pistol Pack
1911's
Bob Tail RZ 10mm - Bob Tail RZ 38 Super by Keith @ DW - DW 38 Super Guardian
1 Guest(s)