Register
Log In
Home
June 13, 2022
Offline
I stubbed along the forum to learn more about my new to me Palmer B00 15-2 I just bought and try and figure out why the timing is off. I plan to give a good cleaning and replace the spring first.
I also have a 1911 PM10-s that I absolutely love to shoot.
February 16, 2016
Offline
to the 
Supporter
DWF Supporters
June 11, 2016
Offline
Welcome to the Forum from Wisconsin. If you get a chance post some pictures.
DWF Supporters
July 12, 2020
Offline
Welcome to the forum from PA! I know the PM10's are a fun shoot!
June 13, 2022
Offline
I forgot.. I’m from SE Michigan.
Supporter
DWF Supporters
June 11, 2016
Offline
Very nice thanks for the pictures.
Supporter
Dans Club
March 25, 2013
Offline
Is your 15-2 spitting propellent? What are your symptoms of timing being off? Off center firing pin mark? Could just be the barrel cylinder gap. You came to the right place. Don't take it to a gunsmith. Most are woefully ignorant about Dan Wesson revolvers.
June 13, 2022
Offline
Ole Dog said
Is your 15-2 spitting propellent? What are your symptoms of timing being off? Off center firing pin mark? Could just be the barrel cylinder gap. You came to the right place. Don't take it to a gunsmith. Most are woefully ignorant about Dan Wesson revolvers.
It could be I really didn’t notice that.
Supporter
Dans Club
March 25, 2013
Offline
Hard to tell about the firing pin mark from the photos. If the gap is too big it will spit propellent. Do you have a barrel tool. Read the forum about setting the gap. Factory says six thousandths of an inch on the proudest chamber. Measure all six chambers. I use a automotive feeler guage instead of the shim they provide. Do not force the shim in. It will push the cylinder back against the dedent ball and result in too small a gap. I would use 4 thousandths of an inch on a 15-2. Take the barrel tool with you when you shoot. Always unload when adjusting the gap. When you tighten the barrel nut put a thumb against the forcing cone so the barrel doesn't turn. Don't over tighten the nut. Snug is good enough.
February 16, 2016
Offline
Jay191115-2 said
Ole Dog said
Off center firing pin mark?
It could be I really didn’t notice that.
That firing pin mark is way off.
June 13, 2022
Offline
I ordered a new hand, mine looks modified maybe a little to much.
1 Guest(s)
