Register
Log In
Home
January 24, 2011
Offline
My mod. 44 has a egged out hammer pivot pin hole .The taper for the pin is off center so the pin dosent go all the way through on the other side.Also the hole looks like it is not straight,when assembled the hammer looks angled in the frame.The hole is 11/64 ths on the side away from the taper and just a little smaller on the tapered side.When you move the hammer the pin moves around.
Has anyone else had this problem it looks like a factory defect.I haven't called cz yet as I'm not the original owner.Maybe somebody can ream the holes true and make a new pin. I assume the hammer hole is harder than the hinges of hell.Any suggestions?
the dealer I bought it from will take it back but i realy wanted a dan wesson and I have what amounts to 345.00 in it so I could put some repair money in and still be ok I think.
thanks in advance for any info Hayseed.
Range Officer
Range Officers
Dans Club
March 27, 2009
Offline
amn I don't know on that one! None of my 44's have any problems like that... Not sure who could help out maybe some of the large frame guys... get some pics any and all of us like to see what you are discribing... not a bad price if you can get it working properly!
DWF Supporters
Dans Club
Moderators
November 17, 2008
Offline
Give Kieth at DW Norwich a call and see what he says. At least you will know what the cost to repair will be. Good luck.
LB
Wisdom is merely the realization of how little one knows, therefore I am wise.
1 Guest(s)
