Register
Log In
Home
May 11, 2020
Offline
Greetings from Minnesooota.I have read in past posts that the Williams Fire Sights for GP100,Redhawk ect. will work on DW.Will they work on a Monson .41 large frame?Looks as if there might be an issue with screw location.Am aware the need to get EWK front.Has anyone have this?Any info or advice would be appreciated.Thanks,BootBoyx2.
Beware of what you ask for, you might just get it.
March 22, 2018
Offline
I know that the rear sight will fit on a small frame Dan, but I'm not sure about the large frame. I did replace the rear sight on my 715 with one.
https://www.danwessonforum.com/forum/reloading/new-williams-firesights/
Dans Club
December 5, 2008
Offline
They also work on later model 44s because they used the same rear sight as small frame guns. I do not have a 41 so I cannot speak for them.
May 11, 2020
Offline
Thanks garryj/snake-eye,I will keep an eye out for another members input.Holding off on buying one until then.Don`t have one of those NEW phones with a camera on it to post a picture for comparison.Thanks again.
Beware of what you ask for, you might just get it.
August 17, 2020
Offline
Anyone know of a rear sight that will fit a lower serial number Monson 44? Apparently the Millett DW00003 and DW00004 part numbers are what I'm after, but about like finding a juicy dinosaur steak these days. Any other options?
Dans Club
December 5, 2008
Offline
I have a Series 100 Millet for Dan Wesson, but it definitely fits small frame and later large frames.
In order to be sure, you could measure the distance between the retaining pin hole and the vertical adjusting/retaining screw hole. That would nail down which one you need.
I'm not aware of another option for the earlier (longer) rear sight for the large frame.
1 Guest(s)
