Register
Log In
Home
Dans Club
August 13, 2022
Offline
This Allen head screw was in the box with the gun I just purchased https://www.danwessonforum.com/forum/revolvers/14-2-id/
The DW tool Allen wrench fits the screw…any idea what it goes to?
thanks
jack
DWF Supporters
July 12, 2020
Offline
Supporter
Dans Club
March 25, 2013
Offline
That is why your gun is inoperative. Put it in, don't over tighten. Snug is good.
Supporter
Dans Club
March 25, 2013
Offline
Top right side of frame. Behind the cylinder.
February 21, 2011
Offline
Isn't that the location of the cross-pin for the firing pin?
I don't recall a screw there?
I'm thinking side-plate screw too? Normally hidden under the grip on the Left hand side.
Matthew Quigley on handguns:
“I said I never had much use for one. Never said
I didn't know how to use it.”
Supporter
Dans Club
March 25, 2013
Offline
My bad. I am dyslexic a bit. I wasn't holding my hand over my heart. LEFT SIDE of course. 🙄
February 8, 2014
Online
Steve S.
February 21, 2011
Offline
Matthew Quigley on handguns:
“I said I never had much use for one. Never said
I didn't know how to use it.”
Dans Club
August 13, 2022
Offline
the gun is working fine, the screw was just lose in the box
the comments about going in the side plate on left side was the clue i needed
the screw there now is a common not allen screw. Took at the common screw, it is a little longer than the allen head screw.
Replaced with the allen screw…all working well
strange why the common head screw was in the gun
thanks for the help
Supporter
Dans Club
March 25, 2013
Offline
The former owner didn't realize the screw was in the box and substituted the longer wrong screw. 
. Anyone who needs a sideplate screw should PM me. I have a number of them. This offer is for a limited time of 6 months. 😏
Dans Club
August 13, 2022
Offline
Just curious why the wrong screw was used in the first place...interesting
Thanks
September 28, 2008
Offline
One of my 15-2's had a phillips screw in the top sideplate hole. I didn't notice it when I looked over the pics on GB. No big deal, I have a bunch of parts, including about 20 of the stock screws. I'm assumming that the previous owner had the screw and ground it off until it was short enough. This is the gun today:
1 Guest(s)
