December 29, 2021
Thread size for the 357 is 17/32-40.
Pulled from another thread in the forum.
https://www.danwessonforum.com/forum/reloading/thread-sizes-of-model-15-and-44/
Dans Club
February 24, 2013
I recently asked Bob for specs on the 15” 357 mag barrel, here was his response:
Hey Kurt, I don’t have those specs. I'm not sure where the prints to the 15 inch are. They can use everything from a shorter barrel and adjust length to flush with the shroud when it's held on the frame. Here is what I have. Bob
Barrel thread .531-40 uns-3a
Rate of twist 1 in 18.75
Forcing cone .007 length don’t have exact angle
Crown .020 deep no specific diameter
Ive read in an older thread here on DWF the forcing cone angle is 11-degrees. Also, at some point (Norwich?) DW offered the 1:14 twist for 10”, 12” & 15” barrels to help stabilize heavy bullets used by silhouette shooters trying to knock down heavy steel targets at 200yd distances.
August 8, 2016
SkereD53 said
I was close, that's not an easy size to find. Thanks for the info.My 357 dies arrive today , pills arrived Monday, plenty of primers und powder on hand.
Hopefully you bought projectiles from Roze. Literally the best deal going and very well made.
Roze Distribution: 38 Special (.357 Diameter) - 158 GR JSP, 2,000 to 9,999
You don't have to buy 2k. If you only add 1 to your cart it will be 1k and the price will be $124.15 shipped
Roze Distribution: 38 Special (.357 Diameter) - 158 GR JSP $ per 1000
1 Guest(s)