Register
Log In
July 17, 2009
Offline
Does any one know gun smiths that work on Dan wessons?
I need my 22 cylinder worked on sunce the chambers were not finished properly, and I need the yoke straightened unless I can buy a new yoke.
Or if not is there a reamer that I can buy myself and cut the throats and chambers?
Dans Club
April 18, 2014
Offline
As close as you are, I would just send it to Norwich factory. They would be the best gunsmiths for that job and in your area.
Oath Keeper #021479 NRA #206814004
Member AAGSR Member AGA #83120600233
"To preserve liberty, it is essential that the whole body of the people always possess arms and be taught alike, especially when young, how to use them."
Richard Henry Lee
American Statesman, 1788
July 17, 2009
Offline
Ok, I feel a bit stupid now 
Thanks
Dans Club
March 2, 2008
Offline
ese927 said
As close as you are, I would just send it to Norwich factory. They would be the best gunsmiths for that job and in your area.
Actually, DW in Norwich is pretty much the best place for DW revolver work.
I had some refinishing work done several years ago on a 15-2, and thru sheer dumb luck my local gunsmith ended up doing a great job of tuning, this was before the AJT was created.Â
And don't feel stupid, DWF is a place to get help, and Cecil (ese927) is a pretty good guy to listen to
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
1 Guest(s)
