Register
Log In
Home
October 10, 2012
Offline
Ive got a dan wesson 15-2 and put a hogue grip on it when i did it never tightened up and i ran the bolt in too far that the hammer wouldnt lock.After backing out the bolt the hammer would lock again and i thought all was ok but when i went to the range the gun works in double action fine but will not turn the cylinder in single action any ideas what i messed up??
October 11, 2009
Offline
Back the grip screw out 2 or 3 turns.
October 10, 2012
Offline
Tried that first pulled the scope off and found the problem the spring is broke that hooks to the transfer bar anyone know where i can get another one??? Thanks for the reply
Dans Club
March 2, 2008
Offline
A complete spring kit is available from DW in Norwich.
https://danwessonforum.com/dwf-content/documents/2009_pricelist.pdf
DO NOT call CZ or go through any CZ links, they got nuthin' for you on DW stuff.
Priscilla or Genny will take care of you, but be aware that most of the Northeast is getting served a major crap sandwich from Mother Nature starting about 6 AM Monday.
I went to a bookstore and asked the saleswoman "Were is the Self Help Section?" She said if she told me, it would defeat the purpose.
George Carlin
October 10, 2012
Offline
Do you happen to have a number to order at thanks very much
October 10, 2012
Offline
Thanks steve found it
February 14, 2012
Offline
I just replaced mine and got it from EWK arms Link at the right of page. Here in 3 days and its $4.95.
October 10, 2012
Offline
Thabks for all the replies i pulled the sideplate and spring was just unhooked put it back on and every thing works great ordered a new spring should be in a few days thanks for everyones help,Darren
1 Guest(s)
