Register
Log In
Home
August 28, 2008
Offline
I have been going through my recently purchased Model 15-2 to give it a good tune up before I start shooting much. I gave it a good internal cleanup and polish, re-cut the almost nonexistent forcing cone. The only thing left is to remove the little bit of end shake and it will be ready for the range. I have already measured everything and have the shim made I just need to get the cylinder off the crane. The question is does it have right hand or left hand threads? I gave it a little pressure both ways but it's on there tight and I would like to know before applying more force.
January 22, 2008
Offline
Hey Reb,
I have a book at home that goes into detail about disassmbling the DW and should have this information in it. I'm traveling this week and will be back home tomorrow night and will try to post info then or saturday.
Jody
January 22, 2008
Offline
This article is already here it goes into detail on page two.
https://www.danwessonforum.com/wp-content/uploads/DW_357.pdf
Dave
August 28, 2008
Offline
As many times as I have looked at that article in the past somehow I missed that part.
Thanks
1 Guest(s)
